Seat back mustīe locked in place and the seat mounting may not be moved to facilitate system installation. ok, i just looked over the rules, and i read that in a single cab, fullsize truck, the box/sub/amplifiers must remain behind the locked position seat backs. Where most steps come down about 2 to 3 inches below. Of the “b” post but must not extend further forward than the rear of the truck seat back. The Power Step offers a significantly lower drop than traditional running board designs. In both or either of these cases, theĮnclosure or speaker will not be allowed to protrude forward of the “B” pillars nor may the enclosure orĪny devices affixed to it protrude above the bottom of the rear or side glass panels.Įxception: In the case of a single cab pickup truck the box, speakers, and amplifiers may extend forward The area behind the “B” pillars will be considered cargo area.
Single cab amp steps full size#
In less than full size trucks or trucks with side facing rear seats, Jump to Latest Follow 1 - 15 of 15 Posts. 1999-2010 Super Duty General Aftermarket. in this thread in this sub-forum in the entire site. In full size trucks originally equipped with forward facing rear seats, the cargo area will be defined asīeing under or behind the rear seat only. Does anybody know if the amp research power steps from a crew cab fit on a ext cab. Although now i cannot find that statement, but i sure hope your right Fish.
Below was copied from the rules, and i know I'm not making it up, I'm pretty sure somewhere or it used to state that amplifiers were allowed under the seat as long as they did not sit forward the front most seat mounting bolts. Well this is what I'm hoping for, just trying to clear up some grey area.
0 kommentar(er)
